Protects absorbent, sensitive ceramic finishes, and grout against
stains. Prevents penetration of oil, grease, and water to a high degree, making
maintenance easier. Poses no health hazard once the product has dried. Ready to
use, indoor and outdoor sealer, no gloss long term protection.
A special product from the
LITHOFIN-Range for ceramics, quarry tiles and porcelain (KF). This ready-to-use
special impregnator is solvent-based and contains high-quality water and oil
Density: approx. 0,78 g/cm³
Appearance: liquid, colourless, clear
Flash Point: approx. 23°C
Reduction in Water Absorption: 90 to 95%
Lithofin KF Stain-Stop penetrates the surface and coats the
capillaries with an extremely thin, invisible film. Oil, grease, and water are
not absorbed by the surface, but instead remain on the surface. During this
time, dirt can easily be removed without leaving stains. The effectiveness
depends on the amount of product absorbed by the surface. The characteristic
appearance of the surface material is not or only slightly altered.
Field of Use:
For protecting unglazed ceramics against stains and for facilitating
every-day maintenance. Highly recommended for use in kitchens, bathrooms, and
other areas where contact with water and oil is likely.
Please Note: Lithofin KF Stain-Stop does
not or only slightly affect the slip resistance properties of the surface.
Directions for Use:
The surface to be treated must be completely dry and clean.
Where no prior experience exists or in cases of doubt, try the product in an
inconspicuous area prior to use. Areas should be treated in sections of approx.
10 to 15m².
highly absorbent surfaces: evenly and generously apply Lithofin KF Stain-Stop
with a brush or roller. Avoid foam.
less absorbent surfaces: use a brush or a cloth. After approx. 20 minutes,
apply Lithofin KF Stain-Stop again to ensure that the entire surface is
saturated. Then carefully remove all surface residues with a cloth. On large
areas use a squeegee and a polishing machine with a white pad. Do not allow any
product to dry on the surface. On highly absorbent surfaces, a second
application after approx. 24 hours may be necessary.
Attention! the liquid product must
sink into the surface. Do not allow the product to dry on the surface. Dry
residues will not be removable after 6 hours. Always try the product in an
inconspicuous area prior to use. Lithofin KF Stain-Stop can only be used on
absorbent and completely dry surfaces. Glass, ceramics, wood, and other
surfaces sensitive to solvents must be protected against splashes.
Application Temperature: the temperature of
the surface should be between 5°C and 25°C. Switch off underfloor heating.
Drying Time: most solvents will
evaporate within two hours. The product will be fully effective after approx.
Coverage: depends on the absorbency
of the material.
Estimates: clay slabs: 4 to 8m²/litre, Unglazed quarry tiles: 8 to 12m²/litre
Durability: up to 5 years in outdoor
areas. Indoors, the durability depends on the care products used. Strong
de-greasing or layer forming products are not suitable. For regular
maintenance, we recommend Lithofin KF Easy-Care.
Storage: Keep closed, cool and dry. Shelf life
of up to 3 years. Open containers should be used quickly.