EPOXY PRIMER - 2 COMPONENTS

Your Price: €64.94 (€52.80 exc VAT)
Part Number:64

Choose Options

BULK SAVER

TWO-COMPONENT EPOXY PRIMER FOR STRENGTHENING THE RESISTANCE OF CEMENT

 

KEY FEATURES:

·        - Increases abrasion resistance

·       - Creates a coating resistant to aggressive chemicals

·        - Impregnates concrete and reduces absorption

·        - Improves the adhesion of adhesives and epoxy coatings


APPLICATION:

Anhydrous reactive epoxy-based resin is used for priming and reinforcing weak mineral surfaces

before the application of insulating coatings of all kinds, as well as mortars and cement-based adhesives. 

It is recommended for strengthening absorbent cement screeds and as a penetration agent for epoxy resin systems. 

The product increases the surface's resistance to abrasion and the effects of fresh and sea water, gasoline, oils, fats as well as many types of alkalis, acids and other

chemicals. It can be used to impregnate the surface of concrete intended for direct use, for natural stone, brick and clinker.


PROPERTIES:

TILEFIX EPOXY PRIMER is a product with low viscosity.

It creates a two-component epoxy composition which when dried has an increased resistance to acids, bases and alkalis.


BASE PREPARATION:

The base must be mature, dry, clean and free from oily dirt and other substances that reduce absorption. 

It cannot be frozen. The base to be impregnated should be at least class B 15, 

power coated, sanded, free of bleeding water, degreased and free from dust. 

Concrete moisture must be maximum 4% and base temperature not lower than 10°C. Bituminous and asphalt bases are not suitable for coating. 

Glazed, sintered and smoothed surfaces should be sanded.

 

HOW TO USE:

 Prior to the mixing of the two components, pre-mix them separately in their packaging. Next, add component B to component A. 

Mix using a low speed mixer. Mixing time - 3 minutes. After mixing, there should be no visible streaks. 

Apply this solution to the surface using a roller, brush or watering can. Spread to a thin, even layer, leaving no excess in recesses. 

Cover excess product on the surface with quartz sand. If the primer completely penetrates the base, prime it again. 

Do not impregnate non-absorbent surfaces. In order to clarify details please contact our technical advisory services. 

If using the product contrary to the instructions, the manufacturer is not responsible for the quality of the protection made.


Related Items