DEEP PENETRATING PREPARATION FOR PRIMING AND REINFORCING ABSORBENT SUBSTRATES
KEY FEATURES:
- Quick setting
- For walls,
floors and ceilings
- Reduces
absorption
- Improves
adhesion
- Prevents dusting
APPLICATION:
Intended for
priming and reinforcing old and new over-absorbent surfaces. Reduces absorption
of
lime and
gypsum plaster, drywall and anhydrite screeds, aerated concrete units, clay
bricks and
sand-lime
bricks. Reinforces old, dusty surfaces and evens out the bonding time of adhesive
mortars,
fillers,
levelling and self-levelling compounds. Recommended before the installation of floors
and floor
bases, mineral plasters and before painting. Suitable for priming chipboard and
wood based
boards before
gluing ceramic tiles. For indoor and outdoor use.
PROPERTIES:
It is a
product made using the highest quality aqueous dispersion of acrylic resin. It
has a great
ability to
penetrate, penetrates deeply into the surface, which strengthens it and evens
out the
absorption
capacity over the entire surface. Prevents the absorption of excess moisture
from
mortar to the
surface and allows for uniform binding rate as well as to obtain the
appropriate
strength
parameters. It is characterised by rapid drying. Surface primed with the
product improves
the adhesion
of adhesives, plasters and other mortars, and reduces paint consumption. After
drying, the
product is colourless.
BASE PREPARATION:
The base
should be dry, clean and free from dust, grease and old paint. Remove dirt and
layers with
poor adhesion.
PREPARATION:
It is an emulsion ready for immediate use.
Do not combine
it with other similar products. Dilution in the ratio 1:1 is allowed.
HOW TO USE:
The product is
preferably applied undiluted with a brush, roller or by spraying as a thin
uniform
layer. For the first priming of strongly absorbent surfaces, an aqueous solution of the
product in
the ratio 1:1
may be used. After the first coat has dried, repeat the impregnation using
undiluted
product. Do
not work in the rain and at temperatures below 5°C. The use of surface and
subsequent
stages of work
such as painting, wallpapering, laying tiles or filling, etc., should be
started after
complete
drying of the preparation, i.e. after about 2 hours after application.
CONSUMPTION:
Depending on
the absorbency of the base. On average, consumption is 0.05 - 0.2 kg per 1m²
TOOL CLEANING:
Clean with
clean water immediately after use.
STORAGE AND TRANSPORT:
The emulsion
must be transported and stored in tightly sealed original containers, in
temperatures
above
5ºC. Protect from freezing and overheating 
